Speaker Specific

→ include an extra 6-8 inches on each end when you are measuring for the speaker wire. you'll need the extra material for the speaker connector termination.
→ if you plan to paint the wire directly, use a piece of cardboard as a protective shield behind the speaker wire when spraying the adhesive.
→ be careful not to cut through the clear wire film unless it specifies in the instructions. the speaker wire will continue to function if punctured after installation.
→ use the angle connectors when space is very limited behind your speaker.
→ pin connectors have bendable ends, enabling a good fit in unusual spaces.
→ the 5-way wall box can be installed behind a modified wallplate. contact us for a template.

General FlatWire

→ use a plastic smoother (ie. the rounded edge of a wallplate) to press the wire against the surface.
→ crease the wire for the folds or turns before applying spray adhesive.
→ use super-fine cleaning/sandpaper pads to blend the edges of new paint into old paint.
→ measure twice, cut once-really. we do not recommend splicing flatwire.